|
Lamp-Da 0.1
A compact lantern project
|
Rules deciding when the battery charge must stop. More...
Go to the source code of this file.
Classes | |
| struct | lampda::component::charger::policy::Inputs |
| Snapshot of the measurements used by the charge stop rules. More... | |
| class | lampda::component::charger::policy::ChargeLimiter |
| Track the charge stop state (battery full, over voltage) More... | |
Namespaces | |
| namespace | lampda |
| Program scope. | |
| namespace | lampda::component |
| Medium level logic, above BSP. | |
| namespace | lampda::component::charger |
| Handles the battery charging processes, and power output control. | |
| namespace | lampda::component::charger::policy |
| Charge stop rules, from a snapshot of the battery measurements. | |
Variables | |
| static constexpr uint16_t | lampda::component::charger::policy::fullLevel = 9900 |
| Battery level (percent * 100) from which the battery is considered full. | |
| static constexpr uint16_t | lampda::component::charger::policy::rechargeLevel = 9500 |
| Once full, the charge restarts below this battery level (percent * 100) | |
| static constexpr uint32_t | lampda::component::charger::policy::endOfChargeDeglitch_ms = 5000 |
| The end of charge condition must stay true for this time before the charge is considered done. | |
| static constexpr uint16_t | lampda::component::charger::policy::cellOverVoltageMargin_mV = 10 |
| Accepted cell voltage above the safe maximum (cell imbalance, measure noise) | |
| static constexpr uint16_t | lampda::component::charger::policy::cellOverVoltage_mV = physical_constants::maxSafeLiionVoltage_mV + cellOverVoltageMargin_mV |
| A cell over this voltage stops the charge immediately. | |
| static constexpr uint16_t | lampda::component::charger::policy::packOverVoltage_mV |
| A pack over this voltage stops the charge immediately. | |
| static constexpr uint16_t | lampda::component::charger::policy::cellResumeVoltage_mV = physical_constants::maxSafeLiionVoltage_mV - 20 |
| After an over voltage, the charge can restart when all cells are below this voltage. | |
| static constexpr uint32_t | lampda::component::charger::policy::overVoltagePause_ms = 20000 |
| After an over voltage, the charge stays stopped at least this long (lets the balancer work) | |
Rules deciding when the battery charge must stop.
Pure logic on a measurement snapshot, so that the rules can be unit tested without the charger hardware.